2012 Ski-Doo Summit SP 800R / SP 600 HO, Summit X 800R Replacement seat cover

Description

Listing is for seat cover only, not complete seat assembly.
New aftermarket seat cover for 2012 Ski-Doo Summit SP 800R,  Summit SP 600 HO, Summit X 800R.
As close to OEM as you can get in aftermarket.  Black sides/back with yellow side stripe, yellow top stitching and rubber non slip seating area.
LISTING IS FOR SEAT COVER ONLY. NOT THE COMPLETE SEAT ASSEMBLY.
Please allow 2-5 business days to complete your order. This does not include shipping times. After Labor Day we experience extremely high order volumes, so please plan ahead when placing your order. During the Holidays, please allow extra time to get your seat cover due to production and shipping delays we experience at those times. In off season, Easter through July 4th, we ship once a week.
RETURN POLICY:
Please read the return policy in detail prior to purchase.
We warranty our products to be free of defect and of good quality. If there is an issue with the order on our end, we will make it right no matter where we ship to.
You have 7 days from time of receipt to contact us about a return. We make every effort to take care of our customers.
Our return policy is not valid for customers ordering the wrong cover. If you are not sure, please ask for assistance.
We make every effort to try to list the models the seat cover will fit. In some cases we may not have all models listed and may have to look it up for you, so feel free to ask any and all questions prior to purchase to ensure fit. If the listing says it will fit ONLY these XXX models, that means it only fits those models and nothing else.
Installation. Unless specified with special instructions, most seat covers are installed by removing your stock seat cover and installing the new one using a staple gun. For most Arctic Cats, you will need to use the existing lumbar seam rod(metal rod that goes in the lumbar seam where the straps are attached to the seat) and the U shaped rod that holds the straps through the foam from your old seat. Those are not supplied. A fabric steamer(hand held ones work fine and are available at Walmart or other department stores for under ) work very well to help remove the remaining wrinkles. You can also use a hair dryer carefully on low heat. Some seat covers or seat mod kits may require the use of 3M 90 Spray(Home Depot, Hobby Lobby, Joannes Fabric, and other hardware stores) adhesive to assist in the installation. We will usually note in the listing any special instructions needed if applicable. To save on trees and waste, we do not include instructions with the shipment.
Most seats do not come with tail light holes cut out. Because these patterns may fit multiple models that had a tail light mounted on the tunnel, we do not cut them out and leave that for you to complete. This is the case with most Arctic Cat, Polaris and Yamaha seats. Most Skidoo seats have a recessed tail light pocket and that is included as part of the pattern. Please feel free to ask any questions we will help out where we can.
We are constantly working on adding new models to our line up. Please visit our Ebay store to see our listings. If you do not see what you need, please ask and we will assist you.
Please do not use a knife to open the box when you receive the cover, to avoid damage to the vinyl.
International Buyers – Please Note:
Import duties, taxes and charges are
not included
in the item price or shipping charges. These charges are the buyer's responsibility.
Please check with your country's customs office to determine what these additional costs will be prior to bidding/buying.
These charges are normally collected by the delivering freight (shipping) company or when you pick the item up – do not confuse them for additional shipping charges.
We do not mark merchandise values below value or mark items as "gifts" - US and International government regulations prohibit such behavior.