Akoma Hound Heater Dog House Heater, Outdoor Pet Furnace 300w - 6 Foot Cord

Description

About Us
Akoma Pet Products is here to support your pet's overall health with hemp and other natural ingredients.
Check out our new pet supplements!
Calming Dog Chews
Skin & Coat Dog Chews
Hip & Joint Dog Chews
Digestive Dog Chews
Dental Water Additive
Dog Ear Wash Wipes
Patented design with safety, simplicity and efficiency in mind
The Akoma Hound Heater Deluxe is the best choice to keep your dog safe, warm and comfortable this winter.
LONG LASTING: Hound Heater Deluxe lasts for years (100,000 on/off cycles) and is powered by a long-life 300W heating element.
SAFE CONSTRUCTION: Features heavy duty chew-proof cord and rounded corners for added safety. Internal heat shield protects all wires and components.
SAVES ENERGY: Hound Heater Deluxe disperses safe, dry heat up to 75 feet and only runs when needed.
SET IT & FORGET IT: Thermo sensing bulb allows for accurate control of the heat in your pet’s house.
EASY TO INSTALL: Special mounting bracket allows the furnace to be mounted on igloo type houses.
SAFE, DRY HEAT
Internal heat shield keeps the front from getting hot, allowing your pet to lay directly against the lower half of the unit without any danger of getting burned. Quiet, forced-air fan disperses heat. Please follow installation instructions. Unit is made of 16-gauge powder-coated steel.
EASY THERMOSTAT ACCESS
Thermostat is easy to access and replaceable. Adjusts from 30°F to 100°F. Most people will typically set their thermostat just above medium. Average temperature ranges inside insulated pet house with a door or flap:
Low to Medium = 32°F to 50°F
Medium to High = 50°F to 80°F
CHEW PROOF CORD
Hound Heater Deluxe comes equipped with a 6 ft, 3 prong grounded cord. Not only is it heavy duty and chew-proof, it has a protective stainless steel spring that covers the entire cord to relieve strain and eliminate cord tension problems. Uses standard home voltage: 120V 60Hz
INSTALLATION INSTRUCTIONS
Install your Hound Heater in 5 easy steps!
Drill a hole through the wall of the house.
Feed the cord through the hole.
Mount the Hound Heater on a vertical wall of your pet house. Do not mount on ceiling or floor. Place heater as high as possible with a minimum of 3 inches from the ceiling.
Set the thermostat.
Plug it in! If you are using an extension cord, it must be a 3 wire, 18 gauge (outdoor rated) grounded plug cord.
To disconnect heater, turn controls to off, and turn off power to heater circuit at main disconnect panel and remove plug from outlet.
Please read Hound Heater manual for full installation instructions.